Thread: Running the Labview Example CAN Talon Code
View Single Post
  #4   Spotlight this post!  
Unread 06-02-2016, 12:50
btcshields6 btcshields6 is offline
Registered User
FRC #4206
  
Join Date: Aug 2014
Location: Texas
Posts: 107
btcshields6 is an unknown quantity at this point
Re: Running the Labview Example CAN Talon Code
So I updated the firmware. When I attempt to run the example, adjusting the speed slider doesn't do anything. Should it? Or am I misunderstanding the example's purpose?

I'm only running one SRX, set to ID 1, so I set the master in the code to 1, and the slave to 2 or 3, since I don't have a second hooked up.

When I manually turn the motor, feedback does register.

Also, an aside, why would it be that three of the SRXs have their B/C CAL lights on and the others do not?
Reply With Quote