Quote:
Originally Posted by techhelpbb
Just curious....you mean you put the terminator in the ON position on the PDP and measured that to be 120Ohms. You also measured the RoboRIO to be 120Ohms.
Right?
You did not put 2 extra resistors on the CAN wires with the RoboRIO and the PDP?
I ask because I have seen people make a mistake like this.
|
Correct
Quote:
|
What are the Talon SRX LEDs doing?
|
MC2 alternates yellow when it's disabled, like it's supposed to. When it's run, the light changes color/blinking with speed (and it drives a motor just fine).
MC1 slternates red, so it's either not connecting or their is a fault. Not connected doesn't make sense because the CAN signal can pass through it. So I'm assuming there's something wrong with MC1 itself.