Thread: Running the Labview Example CAN Talon Code
View Single Post
  #7   Spotlight this post!  
Unread 07-02-2016, 10:38
btcshields6 btcshields6 is offline
Registered User
FRC #4206
  
Join Date: Aug 2014
Location: Texas
Posts: 107
btcshields6 is an unknown quantity at this point
Re: Running the Labview Example CAN Talon Code
I did not have the robot enabled at the time I ran the example code. I didn't think that VIs run with Labview opened and when the robot was tethered were affected by the Driver Station...didn't have any basis for that so I don't know why I thought it.

I'll try again tomorrow, with the robot enabled in the DS, and the code running in Labview.

I'll check the brake/coast modes. Thank you!
Reply With Quote