|
Re: 8020 fastener question
Start with a hanger bolt threaded into both pieces. Then use mending plates on each side that you can fit it. A piece of 1-1/2" x 1-1/2" x 1/8" c-channel would make a great gusset for this. We used this size c-channel on our 2013 robot, and I believe it's the size of the old c-channel kit chassis.
__________________
If you can't find time to do it right, how are you going to find time to do it over?
If you don't pass it on, it never happened.
Robots are great, but inspiration is the reason we're here.
Friends don't let friends use master links.
|