Thread: SD540 Motor controllers won't run in reverse
View Single Post
  #2   Spotlight this post!  
Unread 15-02-2016, 07:23
Unsung FIRST Hero
Al Skierkiewicz Al Skierkiewicz is offline
Broadcast Eng/Chief Robot Inspector
AKA: Big Al WFFA 2005
FRC #0111 (WildStang)
Team Role: Engineer
  
Join Date: Jun 2001
Rookie Year: 1996
Location: Wheeling, IL
Posts: 10,766
Al Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond reputeAl Skierkiewicz has a reputation beyond repute
Re: SD540 Motor controllers won't run in reverse
Tim,
If the controller is satisfied with the calibration procedure, then you likely have a hole in your software. When you expect the motor to reverse, what is the motor actually doing? Is it moving or is it just stationary? Be aware that limit switch input may affect operation. Also check the position of your DIP switches on the bottom.
__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.
Last edited by Al Skierkiewicz : 15-02-2016 at 07:26.