Emphasis mine:
Quote:
|
Originally Posted by R82
“Working” air pressure on the ROBOT must be no greater than 60 psi and must be provided through a single primary adjustable, relieving, pressure regulator.
Norgren regulator P/N: R07-100-RNEA or Monnier P/N: 101-3002-1 recommended.
|
Looking at the spec sheet, I don't see anything about this being a relieving regulator. That is, if the low side pressure is increased to greater than 60 psi (e.g. through mechanical compression of a cylinder that pushes air back through the system), the regulator is required to relieve that excess pressure.