Thread: We need help getting motors moving using Labview!!!
View Single Post
  #3   Spotlight this post!  
Unread 15-02-2016, 15:42
ebmonon36's Avatar
ebmonon36 ebmonon36 is offline
Registered User
AKA: Eric Bredehoeft
FRC #1018 (Robodevils)
Team Role: Mentor
  
Join Date: Dec 2002
Rookie Year: 2003
Location: Indianapolis, IN
Posts: 428
ebmonon36 has much to be proud ofebmonon36 has much to be proud ofebmonon36 has much to be proud ofebmonon36 has much to be proud ofebmonon36 has much to be proud ofebmonon36 has much to be proud ofebmonon36 has much to be proud ofebmonon36 has much to be proud ofebmonon36 has much to be proud of
Send a message via AIM to ebmonon36
Re: We need help getting motors moving using Labview!!!
It's hard to tell from the small picture, but to me it looks like your PWM cables are plugged in with the white wire toward the outside of the roboRIO. This is the signal wire which should line up with the S label for the PWM ports. If your PWM wires are plugged in with the white wire towards the outside, this plug needs to be flipped around so the black wire is towards the outside of the roboRIO.

Eric
Reply With Quote