[cmwilson13]

using a 775 pro for our shooter. we are getting poor performance out of it. pulling 40 amps at 11.5 volts(measured via pdp) and getting smoking hot just free spinning banebots 3 7/8 wheels with a 2 to 1 reduction via belts all running on thunder hex in vexpro bearings, belt center distance was set in cad so they are appropriate tightness. the wheels spin with little to no resistance by hand according to the spec sheet the motor should be somewhere around 12500 rpm, i did not have the ability to measure the rpm at the time but it was no where near that. we did no break in just straight to the shooter for test shots. can the lack of break in cause the poor performance or is there something i am missing.


also whats everyone's opinion on breaking them in. i know some rc people like to break in there 775s at 3v in water for 20 mins