We are experiencing issues with labview program and getting our arm to move to a position on button command. Nearly nothing happens once enabled and button is clicked. The motors stutter slighty if touched, but after there is no response. yes we did update firmware, set up individual id's and searched the software reference manual
Here are the begin, teleop, and PID values.
https://www.dropbox.com/s/ecvsyzkcb0...13%29.png?dl=0
https://www.dropbox.com/s/duw2u37fx7...14%29.png?dl=0
https://www.dropbox.com/s/n220tfz4zv...15%29.png?dl=0
Any help appreciated