View Single Post
  #1   Spotlight this post!  
Unread 22-02-2016, 11:41
billay.jpeg billay.jpeg is offline
Registered User
FRC #4053
 
Join Date: Feb 2016
Location: Louisiana
Posts: 1
billay.jpeg is an unknown quantity at this point
PCM not powering on

Recently we've had our pneumatic control module working when the robot turned on where the status light would blink green once turned on. Now there is no light when power goes through the module. We've checked the power going to it and it is sending a strong 12v and the 20a fuse on the PD board is good. Do we need to come to conclusion that it is busted or are we just missing something?

Everything is wired on the PCM including CAN wires, compressor, switch, and one solenoid; if that helps.