|
Re: HELP NEEDED: Solenoids not firing
If the solenoids aren't firing when the PCM leds say they should,
- Check that the solenoid wires aren't reversed
- Check that the solenoids are getting at least 30 psi at their input port
If the compressor is not operating automatically,
- Enable the robot
- Jumper over the pressure switch to test if you can force the compressor on
- Check your code and remove ALL references to any compressor (it gets instantiated behind the scenes when you create any solenoid)
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
|