|
To download code you need to
go to Parallaxinc.com and get the latest Stamp2 support software (V1.3 -- it is free) (download the latest Stamp2 manual while you are there)
go to InnovationFirst.com to get the latest Default Code
go to the whitepaper section of this websit to get my paper on Innovation First Hardware & the Default Code (the seminar should be online at the Nasa site by now, but I have not checked)
look at the code and make chances you feel are needed
connect your computer and the RC via a 9 pin connector
download the code
cross your fingers as you hit robot reset to run your code.
ask us here specific questions as you run into problems.
Good luck.
Joe J
|