|
Re: Snowblower Motor driveshaft
Depends on what machining capability you have access to, and what other sprockets you have in hand.
If you have some 1/2 hex sprockets-
1) Best bet would be to water-jet a DD Hex insert
2) Mill a DD insert in Hex Shaft Stock.
3) Not the best fit, but you could also try just a 10mm center hole in a lathe. And then use preferably two set screw against the two flats.
__________________
Thank you 2016 Alliance Partners - 948, 1510, 2046, 2521, 2980, 2990, 4911, 4683
Last edited by InFlight : 01-03-2016 at 10:51.
|