Thread: Bad MiniCIMs... failing to consistently start?
View Single Post
  #10   Spotlight this post!  
Unread 01-03-2016, 12:09
JackFisher's Avatar
JackFisher JackFisher is offline
Registered User
FRC #0973 (Greybots)
Team Role: Engineer
  
Join Date: Jun 2013
Rookie Year: 2012
Location: atascadero
Posts: 39
JackFisher has much to be proud ofJackFisher has much to be proud ofJackFisher has much to be proud ofJackFisher has much to be proud ofJackFisher has much to be proud ofJackFisher has much to be proud ofJackFisher has much to be proud ofJackFisher has much to be proud ofJackFisher has much to be proud of
Re: Bad MiniCIMs... failing to consistently start?
How tight was the press fit onto the motor shafts? If it was too tight, and you didn't support the other end of the motor properly while pressing them on, this would probably be the most likely reason the motors are damaged.