Quote:
Originally Posted by Jay Burnett
How are you getting the wires from the Talon srx to the Power Distribution Board? I assume some sort of slip ring, but i could be wrong. Thanks, and Great robot!
|
We tested sliprings. The CAN bus functioned without issue through 4 sliprings. We removed them because the 12 (6 on each side) stiff 12 gauge wires were a mess. They may go back on the bot, but it is working pretty well with plain old wires.
A multiturn hard stop is also in the design. But they were removed after we had one steel nut gall to an aluminum shaft. It took two very long wrenches to remove them. They may go back on later.
The SRX mag encoders in absolute mode are really nice for this application. They keep track of rotations even through a Roborio reboot. As long as the wires are unwound when power is first applied, we should know how many times the wires are twisted.
Right now it is just wires and software.