[Brandon Holley]

Originally Posted by Michael Corsetto

1. We are saving ~ .6 lbs by using two PGU14 and one PRU14. Even more important, we are saving lots of space with these parts. Thank you!

2. We are using the "U" shaped adapters to connect the above regulators and gauges into a tight block. TU14

We also use tube from automation direct (both 1/4" for typical runs and 5/32" tubing for runs that require a smaller bend radius)

We also use a myriad of push to connect fittings from Automation Direct

Automation Direct is one of our go-to suppliers, we probably spend $300-$500 on Automation Direct products annually.

3. I'll PM you address.

Thanks!

-Mike

1. We could save approximately 1 pound by removing all of the brass on our antequated pneumatic setup...

2. We have been using these for our prototype shooter- high Cv solenoids that are super cheap compared to others we've used in the past. More air, MORE POWER!

1.0/AM-526 MANIFOLD 6-STATION FOR AVS-52 SERIES VALVES ALUM
4.0/AM-52BP BLANKING PLATE FOR AM-52 SERIES MANIFOLDS STEEL
6.0/AVS-5211-24D VALVE 4-WAY 2-POS Cv=0.78 24VDC 1/8in FNPT SPOOL SGL-SOL ALUM
3.0/AVS-5221-24D VALVE 4-WAY 2-POS Cv=0.78 24VDC 1/8in FNPT SPOOL DBL-SOL ALUM


3. I will PM you!


-Brando