|
Re: Removing tread from colson wheels
Putting a big hole in a Colson has been done by at least 2 teams that I know of, the first example being the CIM in wheel swerve module. My understanding is that this was done on the lathe with a large drill bit, and then a boring bar.
__________________
2003-2006 | FRC 0176 | Aces High - Student
2007-2010 | FRC 0229 | Division by Zero - Mentor in Training
2011-2013 | FRC 2168 | Aluminum Falcons - Mechanical Mentor
2013-20xx | FRC 0558 | Elm City Robo Squad - Mechanical Mentor
|