Quote:
Originally Posted by marshall
Is this a Windows system? The NavX should show up as a COM device. My best guess from your description is that the USB cable you are using doesn't support data and just does power but I could be wrong.
Scott Libert (Of NavX fame) is competing with his team this weekend so I don't think you'll get an official response until next week but I would try it with a different USB cable.
|
When you run the navX-MXP setup the drivers are installed, at which point the board shows up as a COM port when plugged in via USB. *Be sure that you run the install as administrator otherwise depending upon your system security settings the drivers may fail to install.*