|
Re: Sticky Fault?
What is the sticky fault? If it is compressor related, moving the pressure switch to off board will stop the compressor from trying to run during autonomous. That can also be done through software. Are you powering valves differently? Simultaneous operation of multiple valves might be overdrawing the PCM. Solenoids have an inrush current that can be high and a holding current which is generally fairly low. Solenoids also have a voltage spike when denergized. Simultaneous energizing of one solenoid & denergizing of another might be a problem?
__________________
If you don't know what you should hook up then you should read a data sheet
|