[Libby K]

Q & A 959 has been answered:

Q. Assuming no interfering markings a la Q955, would a robot that completely fills the maximum sizing volume allowed by R3 and is not transparent violate R9-A or any other rule? Assuming that to a reasonable observer that modifications are made to the robot to block shots, may a robot be modified and reinspected during the event to fill the maximum space allowed by R3? Must these modifications be made of transparent materials or have holes cut in them for visibility?
2016-03-23 by FRC1410


A. Before we address your questions, we want to be clear that, as a matter of principal, we try hard to answer the questions asked and avoid inferring what we think the questioner was trying to ask. Given that, please accept our apologies if the information that follows is not what you were seeking. A ROBOT that completely fills the maximum size volume allowed by R3 is not automatically a violation of R9-A, but it is impossible for us to say whether it would violate any other rule. Yes, a ROBOT may be modified after initial Inspection in a variety of ways that are still within the rule set, including increasing its size such that it maxes out the size constraints (and please note T15). There is no requirement that materials used be transparent.