[WizardOfAz]

I am using our EduBot to do some learning while our "big" robot is in quarantine. So I don't know for sure if this issue applies to the full size RC.

I notice that when I power up, and also when I return to bank 0 by "RUN 0" after executing in another bank, I go through the top initialization section of the bank 0 program twice. Evidently, something that gets executed in the I/O setup causes a processor reset. It also zeros out the scratchpad, so what I have put there to communicate a bank 1 result back to bank 0 has been lost.

Can someone clarify this for me, or point me to a source of information?

Thanks
Bill