|
Re: Analog Pressure Sensor Labview Programming
Quote:
Originally Posted by s5511
I used the Get Voltage.Vi and plugged the output into the Volts to PSI.vi, and printed that value, but now I am getting values between -.5 and -.3... Is there anything that I could be doing wrong? The yellow wire on the sensor is plugged into the Signal port on the roboRIO's Analog 0 port.
|
You're getting negative voltages? That doesn't seem right. There is no way you should be getting negative voltages from the RoboRIO.
Here is a link to the VI that we're using to convert the voltage to a pressure.
__________________
Garnet Squadron
FRC 4901
Controls Mentor
@rnazaretian
Previous mentor and student from Team Fusion, FRC 364
Last edited by RyanN : 04-04-2016 at 09:58.
|