Hi all,
Our competition season is over and we would now like to reflash our robot radio back to team mode so we can use it over WiFi again.
I found these instructions:
https://wpilib.screenstepslive.com/s...o-for-home-use
But they don't seem to work. When connected to the radio over Ethernet, my computer gets an IP of 169.254.218.13 (which appears to be what it was using the whole time during competition - whether this is correct is a whole other story, but we had Fun Times (TM) with radio connection issues at our first event).
I run the FRC Radio Configuration Utility and press Configure and it gives me the following error:
"Bridge configuration failed: Failed to change IP address, please check for an adapter with the address: 192.168.1.51. Please ensure the bridge is connected to this computer and try again".
I have no idea where it's getting 192.168.1.51 from...
I can, however, press the "Load Firmware" button, and it appears to find my radio and flash the firmware successfully. However, the firmware still appears to be applying the FRC event configuration.
Is there something I am not doing correctly? Advice would be appreciated!