[Chris Endres]

Originally Posted by Cothron Theiss

This is awesome that it worked well for you. Did you just take the STEP file of the WCP Bevel Gear and print that unmodified or did you mess with the CAD to optimize for Printing?

I know you didn't necessarily ask me, but what I did was I changed the regular VEXPro 15t 20DP bevel gear file to be a 5/16" hex instead of a 3/8" hex. I also removed the bottom step-in on the bevel for a better print. The 5/16" hex allowed us to run hex inside of a 9mm ID 17mm OD ball bearing from McMaster (7804K148).