[Rsave7]

Hello,
We use Labview and have created a custom dashboard at the beginning of the season that we use to get information such a some sensor readings and a few values that we think that our drivers could make use of. We noticed from the beginning that it takes a few seconds for these values to update, probably around 2-2.5 seconds. This has become more and more annoying as the more values we have added and I would like to know if there is a remedy to this or any way to lower the lag on the values updating.

There are no problems or lag whatsoever with controls or the camera that we have on our robot. Both of those update and communicate perfectly but its just the custom value readings on the Dashboard that seem to have a 2 second or so refresh rate.

Any advice or input would be greatly appreciated.

Thanks,
Ryan Saverko
Team 379, The RoboCats