Thread: pic: Another stripped VexPro gear
View Single Post
  #13   Spotlight this post!  
Unread 29-04-2016, 20:16
techhelpbb's Avatar
techhelpbb techhelpbb is offline
Registered User
FRC #0011 (MORT - Team 11)
Team Role: Mentor
  
Join Date: Nov 2010
Rookie Year: 1997
Location: New Jersey
Posts: 1,620
techhelpbb has a reputation beyond reputetechhelpbb has a reputation beyond reputetechhelpbb has a reputation beyond reputetechhelpbb has a reputation beyond reputetechhelpbb has a reputation beyond reputetechhelpbb has a reputation beyond reputetechhelpbb has a reputation beyond reputetechhelpbb has a reputation beyond reputetechhelpbb has a reputation beyond reputetechhelpbb has a reputation beyond reputetechhelpbb has a reputation beyond repute
Re: pic: Another stripped VexPro gear
Steel final gears should be adequate to sort the issue.
Course they are heavier.

Every year I try to avoid broaching stuff but I finally got fed up and bought a #5 5 ton ratcheting arbor press and Dumont push broach. Built a nice stand out of 2x4 with caster's for that 365lb monster.

I also bought a rotary broach and holder but I am sorting issues out on that.

I had 20 and 24 tooth Vex gears because I bought 2 dual CIM Vex ball shifters lightly used from an FRC team on eBay. So I actually have something to test with. Personally I just usually use AndyMark boxes.

If figure as CSA sooner or later I am going to run into these Vex products.
Last edited by techhelpbb : 29-04-2016 at 20:23.
Reply With Quote