|
Re: Wrecked Aluminium from chopsaw
Quote:
Originally Posted by RoboChair
The whole point of the chop saw is that you don't need to mill the block to length first to make a part with it. I can hit +- 0.005" length tolerance on a run of parts with my chop saw and be ready to do everything else to it. 10 seconds, cut, 10 seconds, cut, repeat until done.
Just set it up right so you force everyone to use it right.
Also I really dislike JET. It starts out fine and becomes a huge hassle to maintain.
|
Could you add some detail on how you get those tolerances? Is that with the chop saw setup you posted on the previous page? Are you using any DRO to get that tolerance?
__________________
2016 | Innovation In Controls, Industrial Design, Quality Award, NC District - 4th Seed
|