View Single Post
  #1   Spotlight this post!  
Unread 03-08-2016, 22:11
Tcrump47 Tcrump47 is offline
Yeti 3506-CAD Team
FRC #3506
 
Join Date: Dec 2015
Rookie Year: 2014
Location: Charlotte, NC
Posts: 12
Tcrump47 is an unknown quantity at this point
Re: Custom Gearboxes

Quote:
Originally Posted by asid61 View Post
+1 on everything Nick said, although I think 7075 would be a waste of money compared to just using 6061.
For the standoffs, I design with either Vexpro tube axle (which is a bit large for 10-32) or I buy something like these tubings from McMaster:
http://www.mcmaster.com/#1658t19/=13kl5sw
http://www.mcmaster.com/#89955k459/=13kl6eq
The latter has a slightly smaller ID, so it's better suited for clearance, but it's also steel which is harder to machine.
It's diable to just buy aluminum shafts and drill them, but I find that's more hassle than cutting tubes to length on a lathe.

I design for tapping because I think it's easier, and a bit of loctite blue or just the construction of the chassis secures it. But nuts save you the hassle of tapping and you can make the front and back plates of your gearbox the same. However, if your gearbox is super long, it makes more sense just to use a hexagonal standoff (or thunderhex/hex shaft) and tap both ends for a screw.

I would not make my own custom gearboxes, especially for drivetrain use, unless I have a CNC mill/router or a waterjet. If you only have a manual mill it makes a lot more sense to just buy your gearboxes, unless you want to do something like a flipped CIM gearbox or save money.
We have access to a waterjet for curtain and will probably gain access to a CNC mill (hoping). Thanks for all of the information.
Reply With Quote