|
Re: pic: low profile 3 CIM gearbox
I really like this gearbox profile. Do you usually cut this out on a water jet and drill the holes separate? If it is 100% water jet cut, how do you account for the stream taper when pressing bearings and whatnot into the side plates?
__________________
2015 NC Regional Chairman's Award
2016 NC Guilford District Event Winner
2016 NC Guilford District Chairman's Award
2016 NC District Championship Winner
2016 NC Regional Chairman's Award
2016 NC Woodie Flowers Award Finalist - Lia Schwinghammer
|