|
Re: pic: low profile 3 CIM gearbox
Quote:
Originally Posted by OccamzRazor
I really like this gearbox profile. Do you usually cut this out on a water jet and drill the holes separate? If it is 100% water jet cut, how do you account for the stream taper when pressing bearings and whatnot into the side plates?
|
Once could always have the holes cut small and drill/ream them after the fact.
__________________
Dean's List Semi-finalist 2010
1747 Harrison Boiler Robotics 2008-2010, 2783 Engineers of Tomorrow 2011, Event Volunteer 2012-current
DISCLAIMER: Any opinions/comments posted are solely my personal opinion and does not reflect the views/opinions of FIRST, IndianaFIRST, or any other organization.
|