Thread: Do you use 3d printed mounts?
View Single Post
  #7   Spotlight this post!  
Unread 13-09-2016, 15:47
346CADmen's Avatar
346CADmen 346CADmen is offline
Registered User
FRC #0346
Team Role: Mentor
  
Join Date: Jan 2014
Rookie Year: 2013
Location: Virginia
Posts: 93
346CADmen is a splendid one to behold346CADmen is a splendid one to behold346CADmen is a splendid one to behold346CADmen is a splendid one to behold346CADmen is a splendid one to behold346CADmen is a splendid one to behold346CADmen is a splendid one to behold
Re: Do you use 3d printed mounts?
Quote:
Originally Posted by Michael Hill View Post
We used them for camera mounts, ultrasonic sensor mount, and pneumatic tank mounts (after finding out http://www.andymark.com/product-p/am-2008.htm is too small for http://www.andymark.com/product-p/am-2479.htm, even though they say it's the recommended mount). And it's way too small.
Did you actually order these or was there a typo in your post? The Andy Mark pages you reference do NOT show them as being compatible. And those pages describe the components diameters as being 2.5" and 2.7". While that may be trite, I think cost is a concern too. Printing a clip like the one shown, for our team, would be much more expensive (filament isn't cheap) than the COTS part.
Reply With Quote