Thread: drill motor transmissions
View Single Post
  #1   Spotlight this post!  
Unread 23-01-2002, 22:23
nwagers nwagers is offline
Registered User
#0240 (Mach Vee)
  
Join Date: Oct 2001
Location: Monroe, MI
Posts: 88
nwagers is an unknown quantity at this point
Send a message via AIM to nwagers Send a message via Yahoo to nwagers
Lightbulb drill motor transmissions
Does anyone know the size of the ring needed to lock the drill motor transmissions into low gear? I know where/how to install it. But I am not sure on size. I posted some information on locking the transmissions into high gear in the Whitepapers section.