|
Re: Would this Encoder work? and Encoder Recommendations
I purchased one of these the other day for a personal project.
I wanted 360 PPR, and relatively low cost, so this fit the bill.
When it arrived, I was STUNNED by the build quality!! It is a VERY well built encoder! That said, it is a lot larger than most encoders of this style. It is approx. 1.5" dia. and approx. 1.4" long. I also found that using 4.7K ohm pull up resistors with it made it very stable with my Arduino.
BTW, you can get this in a couple more PPR values.
__________________
CalGames 2009 Autonomous Champion Award winner
Sacramento 2010 Creativity in Design winner, Sacramento 2010 Quarter finalist
2011 Sacramento Finalist, 2011 Madtown Engineering Inspiration Award.
2012 Sacramento Semi-Finals, 2012 Sacramento Innovation in Control Award, 2012 SVR Judges Award.
2012 CalGames Autonomous Challenge Award winner ($$$).
2014 2X Rockwell Automation: Innovation in Control Award (CVR and SAC). Curie Division Gracious Professionalism Award.
2014 Capital City Classic Winner AND Runner Up. Madtown Throwdown: Runner up.
2015 Innovation in Control Award, Sacramento.
2016 Chezy Champs Finalist, 2016 MTTD Finalist
|