Thread: Custom Gears to Fit with Tetrix Gears
View Single Post
  #1   Spotlight this post!  
Unread 06-11-2016, 16:57
Scoutdrago3 Scoutdrago3 is offline
Registered User
FTC #5968
  
Join Date: Nov 2016
Location: New Jersey
Posts: 1
Scoutdrago3 is an unknown quantity at this point
Custom Gears to Fit with Tetrix Gears
Hello,

I'm looking for custom 20-tooth gears that would fit with tetrix gears, but can't seem to find anything. I found some information about general specs of the gears on these forums:

"TETRIX gears have a diametral pitch (DP) of 32 teeth/in, a pressure angle (PA) of 20 degrees, and a face width of 0.250 in" - Nate Laverdure.

I tried Amazon and a few smaller sites and can't find anything. I would just CAD it and try seeing how it holds up 3D printed, but I'm not too great with CADing custom parts, especially not gears with details specifications like that.
Reply With Quote