Quote:
Originally Posted by Jean Tenca
Very cool. I'm curious, is there anything special with the wiring for this? How do you accommodate the motor rotating so many times? I've seen a few robots do motors in rollers in the past, but I've always been unsure as to how exactly they wire them.
|
Richard can correct me if I'm wrong, but from Mike's picture it looks like the CIM is mounted and the spool rotates around the CIM. Not shown in the original picture is a large gear that fits on the end of the VP and bolts to the side of the spool and spins it. If this is right, then there is no need to worry about the CIM wires rotating.