View Single Post
  #15   Spotlight this post!  
Unread 21-11-2016, 01:13
Maxwell777's Avatar
Maxwell777 Maxwell777 is offline
Is allowed to touch stuff now
AKA: Jackson Gray
FRC #0842 (Falcon Robotics)
Team Role: Programmer
 
Join Date: Aug 2013
Rookie Year: 2014
Location: Phoenix, AZ
Posts: 72
Maxwell777 has a spectacular aura aboutMaxwell777 has a spectacular aura aboutMaxwell777 has a spectacular aura about
Re: Rate my Talon SRX breakout (EagleCAD)

Quote:
Originally Posted by asid61 View Post
I have seen people use silicone glue like the kind found in waterproofing applications for insulation, but you might be better served with a simple printed case.
A case would probably be too bulky, the only things at risk of shorting are on the top side, so I figure It wouldn't be to hard to spread some over the top of each board. I was thinking of using some of this shoe-goo stuff we have, which is clear, stupidly strong, and fairly viscous and can be molded with soapy fingers so it's easy to apply, but I don't know of it's electrical properties. I think we may have some silicon glue laying around, so I may try both and see how I like them.
__________________
But why?
Reply With Quote