Thread: Disassembling Pneumatics?
View Single Post
  #5   Spotlight this post!  
Unread 08-12-2016, 20:36
Mike Schreiber's Avatar
Mike Schreiber Mike Schreiber is offline
Registered User
FRC #0067 (The HOT Team)
Team Role: Mentor
  
Join Date: Dec 2006
Rookie Year: 2006
Location: Milford, Michigan
Posts: 472
Mike Schreiber has a reputation beyond reputeMike Schreiber has a reputation beyond reputeMike Schreiber has a reputation beyond reputeMike Schreiber has a reputation beyond reputeMike Schreiber has a reputation beyond reputeMike Schreiber has a reputation beyond reputeMike Schreiber has a reputation beyond reputeMike Schreiber has a reputation beyond reputeMike Schreiber has a reputation beyond reputeMike Schreiber has a reputation beyond reputeMike Schreiber has a reputation beyond repute
Re: Disassembling Pneumatics?
Yea you have to disassemble your fittings etc. It's not fun, but it does make everything fair.

Quote:
Originally Posted by jee7s View Post
Your cut pneumatic tubing would have to be cut again, as well.
At what point is it just stock / scrap? If you had a drawer of pneumatic tubing not attached to anything that was left over from a scrapped robot disassembled ages ago (as I'm sure hundreds of teams have) and you found a piece that was the perfect length, by the book you're required to modify it in some way so that it was fabricated during the build season? Or does the very act of assembling mean it's modified, as it does with bringing in COTS components?
__________________
Mike Schreiber

Kettering University ('09-'13) University of Michigan ('14-'18?)
FLL ('01-'02), FRC Team 27 ('06-'09), Team 397 ('10), Team 3450/314 ('11), Team 67 ('14-'??)
Reply With Quote