Quote:
|
The motor mounts were crap...we had so much torque going through our drive that we would actually end up spinning the drill motors in their mounts until the brushes shattered and were spit out.
|
Are you sure you assembled the drill and transmission correctly. Look inside the drill transmissions and look at the face. There is two ways they can mesh. One way is with those semi circles and the other way is with the actual circles. If you use the semi circles eventually the motors will torque a little bit and move a bit. If you use the cicrular holes the drill motors will stay put. The rule that said you had to switch out the smaller wires on the motors for larger ones.
__________________
If either a public officer or any one else saw a person attempting to cross a bridge which had been ascertained to be unsafe, and there were no time to warn him of his danger, they might seize him and turn him back without any real infringement of his liberty; for liberty consists in doing what one desires, and he does not desire to fall into the river. -Mill
|