[marshall]

Originally Posted by Andy Baker

Keeping stock for plastic molded AndyMark products is not a problem. Our mold shop is about 5 miles away, and they provide fast service. We don't have to keep gobs in stock, due to quick production runs.

We may run out of stock for a molded item for a few days, but it's always back in stock soon.

This is reason #3480 we don't buy molded parts from distant lands.

Sincerely,
Andy B.

Fun fact, at size 12 single spaced Times New Roman with 1 inch margins, you can get ~46 lines on a page so the AndyMark handbook for buying molded parts must be at least 76 pages assuming each reason is at least a single line.

I'm guessing Andy uses that handbook to keep his desk level.