[cbale2000]

Originally Posted by Ether

I'd love to put a scope on those wires and see what the signal looks like at the nodes.

Not sure if we have a scope that works, but assuming we did, how would you go about doing that? Just connect one probe to green and the other to yellow?

Originally Posted by ozrien

Using a star network generally creates more problems on CAN bus than it will solve, and we do not recommend it.

Please read pages 35-37 of the Talon SRX User's Guide.

http://www.ctr-electronics.com/talon...ical_resources

Does Star topology assume both yellow and green wires are connected to the same hub? If that's the case this is not what we did. Our Topology actually looks similar (in my opinion anyways) to the "master cable harness" topology except rather than using a cable we used two busses, one for each color wire.