|
Re: Bumper zone clarification
Mentos,
To insure everyone understands this, under R23 the Bumper Zone is determined during inspection when the robot is standing on the floor. The bumper zone does not change if the robot changes attitude during the climb.
It is meant to address those teams who want to actually manipulate their bumpers so that they move from the fixed position.
R23. BUMPERS must be located entirely within the BUMPER ZONE, which is the volume contained between the floor and a virtual horizontal plane 7 in. (~17 cm) above the floor in reference to the ROBOT standing normally on a flat floor.
__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.
|