Quote:
Originally Posted by mman1506
I'd suggest switching out those shaft clamps for 1/4-20 button heads with a washer in tapped holes on the ends of the hex shaft. Thunderhex stock comes pre drilled with the proper size hole for a 1/4-20 tap if you don't have a lathe. This will save some weight and cost. You could probably increase the distance between your wheels too which is always good thing. |
Thanks yea. We already have over 50 of those hex shaft clamps and as well as the hex shaft but no lathe. I would like to do that but for simplicity sake its much easier since we don't have a lathe. I really appreciate your comment though.
Thanks