[mman1506]

Originally Posted by Massako

do you know anyway of doing that that would be cost effective and easy to manufacture? That's the only reason we haven't adapted that and are ok if it is not perfect. it is primarily there for slight assistance with aligning with the gear lift. we have looked at some implementations of such a method but concluded it would be to difficult for our ability with manufacturing.

Thanks

You could try using a VersaDrop module. The pneumatic cylinder will act as a air spring to give you some suspension travel and you could retract it if necessary. If you add a secondary air pressure regulator you can adjust the air pressure until you are happy with the amount of force it pushes against ground.