Thread: How do we curve an aluminum shooter panel?
View Single Post
  #2   Spotlight this post!  
Unread 14-01-2017, 11:40
Tungrus Tungrus is offline
Registered User
no team
  
Join Date: Mar 2013
Location: Somewhere
Posts: 376
Tungrus is a jewel in the roughTungrus is a jewel in the roughTungrus is a jewel in the roughTungrus is a jewel in the rough
Re: How do we curve an aluminum shooter panel?
sure you can use polycarbonate and bend it. It takes some time and patience. You can compensate imperfection (uneven bending or gents) by Velcro (soft side). Bending 1/8" aluminum sheet is difficult, but if you can get thinner, shape them and laminate. In either case having back support to keep the curvature would help.

Edit: Just make sure that curve does not change after few matches. Supporting in the convex dice will help. In pause we have used wood, which was easier for is to cut ca use it as support.
Last edited by Tungrus : 14-01-2017 at 11:50.
Reply With Quote