Thread: PDP Ports
View Single Post
  #2   Spotlight this post!  
Unread 14-01-2017, 13:54
Tungrus Tungrus is offline
Registered User
no team
 
Join Date: Mar 2013
Location: Somewhere
Posts: 377
Tungrus is a jewel in the roughTungrus is a jewel in the roughTungrus is a jewel in the roughTungrus is a jewel in the rough
Re: PDP Ports

Yes, there is a specific rule. Check the rules please.

R53. Only one wire shall be connected to each WAGO connector on the PDP.


If multi-point distribution of circuit power is needed (e.g. to provide power to multiple PCMs and/or VRMs from one 20A circuit), then all incoming wires may be appropriately spliced into the main lead (e.g. using an insulated terminal block, crimped splice or soldered wire splice), and the single main lead inserted into the WAGO connector to power the circuit.

Last edited by Tungrus : 14-01-2017 at 13:59.
Reply With Quote