|
Re: Using CIMCoders with Talon SRXs
Seeing the Cimcoder is a 5V sensor we used a 4.7K Ohm resistor to Vdd.
If I remember right it was 10k at 12v, but the srx is 5v/3.3v.
We used the CTE breakout for these.
Added- the encoder is 20 cpr, the srx is 4x decode the signal, so you should see 80 native counts per rev in the srx webpage. *going from Memory*
__________________
The sooner we get behind schedule, the more time we have to catch up.
Last edited by tr6scott : 15-01-2017 at 10:39.
Reason: Wrong data initially... then added the native.
|