Quote:
Originally Posted by Roboshant
Note that Andymark is now selling a short version of the shaft (probably a bit short, considering the long only sticks out 7mm). I'm not sure about the construction of the toughbox, but can't you just cut off a couple millimeters from the non-magnet side and push the shaft the outwards further? |
Not really possible without some serious modification, the 1/2" hex gearbox shaft is turned down to 3/8" at the end to fit into a 3/8" round bearing. There is an E-clip which retains the shaft and also ensures good meshing of the gears( if you don't use the E-clip the shaft can fall out).