|
Re: Toughbox Hex Shaft With Magnet
I have not seen this product in person, however if the magnet is the only part too long, perhaps you can remove the magnet, then drill the hole in the shaft deeper with a standard drill in a vise (since there is already a hole) and then push the magnet down farther.
__________________
2003-2006 | FRC 0176 | Aces High - Student
2007-2010 | FRC 0229 | Division by Zero - Mentor in Training
2011-2013 | FRC 2168 | Aluminum Falcons - Mechanical Mentor
2013-20xx | FRC 0558 | Elm City Robo Squad - Mechanical Mentor
|