|
Re: Polycarbonate/Plexiglass Ruling
Quote:
Originally Posted by cadandcookies
This. So many people just call clear plastic "plexi" or "plexiglas"-- whether it's the right thing or not. For competitive robotics, it is just about always the wrong thing.
Also, since nobody explicitly stated what will go wrong:
Lexan basically doesn't shatter. They use specific compositions of it for bulletproof "glass" for this reason. You can even cold-bend the stuff (though I wouldn't generally recommend it) and depending on the use it can be fine. Acrylic on the other hand... well, drop it or hit it with something or try to bend it and see what happens. It shatters. Something into sharp shards. A quite undesirable characteristic for robots. So, polycarbonate, Lexan, or Makrolon are generally good for robot use. Acrylic, Plexiglas, Acrylite, Lucite or Perspex = bad news.
To reiterate everyone else:
Make sure what you are using is polycarbonate and not acrylic or it may very well literally shatter your dreams.
|
Just about the only nice property of acrylic, in my opinion, is that it lasercuts very, very nicely.
__________________
"Mmmmm, chain grease and aluminum shavings..."
"The breakfast of champions!"
Member, FRC Team 449: 2007-2010
Drive Mechanics Lead, FRC Team 449: 2009-2010
Alumnus/Technical Mentor, FRC Team 449: 2010-Present
Lead Technical Mentor, FRC Team 4464: 2012-2015
Technical Mentor, FRC Team 5830: 2015-2016
Last edited by Oblarg : 20-01-2017 at 13:26.
|