View Single Post
  #1   Spotlight this post!  
Unread 26-01-2017, 16:48
RoboBucs RoboBucs is offline
Registered User
FRC #5005
 
Join Date: Jan 2015
Location: Chattanooga, TN
Posts: 77
RoboBucs is an unknown quantity at this point
Motor Controllers Stop Working Below 50% Power in Labview

Rather than gear down our motors, we are trying to just drop the percentage of the power going through the motor controller in Labview. This works until we hit 50%(.5). Anything below 50.1% no longer works, as if no signal is going through to the motor controller. It is a spark motor controller if that helps.

Last edited by RoboBucs : 26-01-2017 at 16:51.
Reply With Quote